JANI-TOR Updated

Twice now, my JANI-TOR 3D printed robot model has broken. Once I dropped it while carrying it, and once it toppled over seemingly on his own on my bureau. Perhaps he’s a bit front heavy.

This second time, the head came clean off, so I took this opportunity to redo the head.

The original head disappointed me because the whole point of this model is JANI-TOR is contemplating a ball. But my original model was not looking at the ball, he was looking far too up and forward:


So I took the opportunity to make an alternate head that is looking towards the ball. Here you see his new head attached, and his old one detached:


There. Fixed it.

Leave a Reply

Your email address will not be published. Required fields are marked *